New
Time Delay Trigger
TRIG-DELAY
A trigger that allows you to delay the signal of another trigger, or loop your prop at a certain interval.
This trigger is easy-to-use, and allows up to an hour of delay time. Place in loop mode to trigger a prop at a desired interval.
To set the delay time:
- Hold the DELAY button until the LED turns blue
- Release DELAY button, now recording the delay length, LED will flash red every second
- Press the DELAY button again when you reach the desired delay time
You can also configure how long the output stays on for, this allows you to directly control devices using the on-board relay (up-to 5A DC).
| Dimensions | 2.5" x 1.95" |
| Supply Voltage | 12 - 24 V DC |
| Outputs | 1 (2 if you count the Normally Closed Output) |
| Output Type | Relay |
| Output Capacity | 5A |
| Isolated Inputs | 1 |
| Enclosure Type | No Enclosure |
| Mounting Screw Size | #4 or M3 |
-
Aamon Duo
$50.00A small but powerful prop controller that makes it easy to program 2-channel animations, a third output is provided for more advanced animations. Power supply not included. -
Reflective Beam Sensor
$20.00Highly accurate trigger, detects objects moving between sensor and reflector. Safe for outdoor use, cover recommended. -
12V Power Supply
$8.00General purpose 12V power supply. Converts 120V AC into 12V DC. Comes with a screw terminal adapter. Item may vary slightly from the picture. -
Foot Switch
$10.00Foot activated switch makes hands-free scaring easy. -
PIR Motion Sensor
$20.00Use this motion sensor to trigger a controller when someone walks near it.New
Can This Directly Control Lighting or Solenoid Valves?
Yes! This trigger has a relay output, so you can use it to control up-to 5A of DC or AC voltage.